Kunshan ammeter manufacturer's introduction of ammeter operation steps

1. Zero calibration: use a flat screwdriver to adjust the zero calibration button.

金彩汇2. Selection of measuring range (estimated by experience or by touch test)

To sum up, there are three look and three ask, first to see the range of the ammeter, generally there is a mark on the dial. After connecting the positive and negative terminals of the ammeter into the circuit, observe the position of the pointer, and you can read. In addition, the ammeter with appropriate range should be selected. Can try to touch first, if the pointer swing is not obvious, then change the small range of the meter. If the pointer swings at a large angle, change the meter with a large range. Generally, the pointer is in the middle of the dial, so the reading is more appropriate.

A look: range. Measuring range of ammeter.

金彩汇Second, see: division value. How much does a small space on the dial represent.

Third look: pointer position. How many index values does the position of the pointer contain.